Die-namics Crafter's Release Foam

Crafter Foam sheets are 8.5 x 4.25", and come in six sheet packs. They are adhesive backed, and may be used with Die-namics to enable your dies to quickly release cardstock. To use, simply die cut Crafters Foam sheets with the adhesive side toward your Die-namic. Once cut, peel the adhesive liner away. Crafter's Foam can also be die cut to add dimension to a flat die cut.
 
Crafters Foam sheets are put on your dies so that the cardstock pops out more easily after cutting out your shape.
 
Step 1: Peel off the paper lining and place your Die-namic cut side down onto the foam.
 
Step 2: Trim around the die shape and set aside the remaining Crafter Foam sheet.
 
Step 3: Run your die through your die cut machine and remove any excess foam pieces.
 
Your die is then ready to use!

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: